What boiler repair involves
Boiler repair covers circulators, zone valves, aquastats, expansion tanks, low-water cutoffs, air separators, thermocouples, gas valves and leaks. We test the whole loop, not just the appliance.
Hot water and steam boiler troubleshooting — circulators, zone valves, aquastats, low-water cutoffs and leaks.
What we usually get called for
- One zone stays cold while the others heat fine
- Banging, knocking or gurgling in the pipes
- Pressure gauge reading too high or dropping steadily
- Water on the floor around the boiler
- Boiler runs constantly without satisfying the thermostat
How we repair it
We repair rather than replace whenever the boiler section is sound. A 30-year-old cast iron boiler with a bad circulator is a repair, not a replacement.
If it's time for new equipment
A leaking boiler section, a cracked block, or repeated flooding on a steam system are the real reasons to replace. We'll show you which one applies.
Questions from Andover homeowners
- Do you work on steam boilers?
- Yes — steam and hot water, gas, propane and oil-fired.
- My pressure keeps climbing. Is that dangerous?
- It needs looking at. Usually it's the expansion tank or a fill valve feeding water in. Shut it down and call us.
Why Andover homeowners choose Noble.
- Two decades of furnaces, boilers, heat pumps and central air
- Family-owned and small on purpose, so the work stays consistent
- Licensed, insured and bonded in New Jersey and Pennsylvania
- Honest answers about what can wait and what can't
- No pressure, no upsells, no mystery invoices
- Voicemail gets a callback the same day — we're usually on a job